Download free PDFBy the way...! Make the stars in any colours you wish. Step by step guide 1.Make sure you have everything you need. You can make the star in two sizes. Join the two parts of the large template with tape at the dotted line.2.Cut out and trim the template. NB: Be very precise. 3.Steam iron the PAP FAB sheet at medium heat to ensure that it is completely flat.4.Draw up the template in pencil on the PAP FAB sheet. Cut two star pieces and four straight pieces. Cut and trim all the pieces.5.Braid two of the straight pieces into the centre of each star as shown.6.Lay two sides of the star together (turn one side at an angle of 45° to the other) .7.Squeeze a small blob of adhesive onto a scrap of paper. Apply adhesive with a brush. Starting at the top, brush adhesive onto one of the sharp-ended strips. 8.Now stick the strips from the lower part to the upper part. Take the straight-ended strip on the right. Glue it to the sharp-ended strip. 9.Brush a little adhesive onto the piece that you have just glued.10.Take the straight-ended strip on the left. Glue it to the point.11.Clip these three parts together until the adhesive has dried.12.Repeat on the other three sides of the intersection. 13.Turn the star over. Repeat the process with adhesive, brush and clips. TIP: If necessary, rinse the brush to avoid lumps forming in the adhesive. 14.When the adhesive is dry, remove all the clips.15.If you wish, make a hole for hanging. Make a linen cord tie.